天富娱乐登录测试

about us
current position: HOME >> News >> Industry News

When using automatic feeding system, we need to pay attention to the following two points:

2018-12-17
Times

Whether the feed rate at the inlet and outlet is reasonable or not.


Whether the feeding and unloading parameters are reasonable or not.


Whether the feed quantity at the inlet and outlet is reasonable or not:


Many destructive equipments use manual elastic pipe to suck materials. In order to facilitate the operation, the elastic pipe is directly pierced into the material barrel or ton bag. The elastic pipe suction outlet is tightened by the tight material, and the strong negative pressure pulls the full material away. In fact, the damage to the automatic feeder is very large, and it is very easy to block the pipeline. The correct method is that the material in the suction port and air constitute a certain mixture ratio of air and substance (that is, the elastic tube can be placed on the material surface), and evenly flow into the feeder under the push of air flow. At this time, we need to plan the elastic tube with the function of reinforcing Qi. If the material backlog time is too long, it may be very hard. At this time, an oscillator is installed on the elastic tube to make a stir to break up small caked materials.


Automatic feeding system


The parameters of loading and unloading time are unreasonable:


Fully automatic feeder can't be equipped with level machine in the silo, so it can only be operated at all times for professional use. So how to set the time parameters with automatic feeder? Whether the manufacturer of automatic feeding machine can give guidance or not, the setting of feeding and unloading time is very simple. In the first use, first set a small hour, then gradually increase according to the direction of each suction. When the material level reaches the suction port, then subtract a second is a reasonable time. The discharging time is to ensure one second after discharging. This has two advantages: a high-speed mixer

The high material level has a great damage to the filter element. This is why some of our customers can use one filter element for two years and some of them can use it for half a year.

Every material can be put clean, the discharging valve in the closed time will not appear with material shut-off, with material shut-off valve on the five or six times a minute of this frequent operation of the seal ring damage is particularly large.


Recently Viewed: