天富娱乐登录测试

about us
current position: HOME >> News >> Industry News

How to Schedule Feeding Time of Feeder

2019-01-26
Times

Many customers think that the feeding time of automatic feeder of punch is not schedulable, and the feeding time of automatic feeder of punch can be scheduled. When the automatic feeder manufacturer is equipped with automatic feeder of punch, the feeding time of automatic feeder will be adjusted to 9 (270) o'clock for initial feeding and 3 (90) o'clock for delivery. Material, such feeding time can basically meet the needs of most stamping products, but according to different products and stamping speed, the need for appropriate scheduling feeding time, the following is for high-speed roller automatic feeding machine, NC numerical control automatic feeding machine and air automatic feeding machine, the three most commonly used automatic feeding machine how Dispatch.


1. Time Scheduling of Fully Automatic Air Feeder

Air automatic feeder regulates feeding time scheduling by pressing down floating rod. When equipment regulates air automatic feeder, a guide plate is equipped on the slider of punch press. The feeding time is controlled by pressing down floating rod through screw on the guide plate. The lifting floating rod is equivalent to a ventilation switch. The air source is closed when the floating rod is depressed, and feeding is carried out when the air source is connected to the air automatic feeder when it reaches the pole. Therefore, the effect of controlling feeding time can be achieved by dispatching the screw depressed length on the guide plate. The more the screw of the guide plate is depressed, the later the feeding time is, and there is also a feeding time of the air automatic feeder. It is controlled by adding solenoid valves. The time schedule of air automatic feeder with solenoid valves is the same as that of NC NC automatic feeder.


2. Delivery Time Scheduling of High Speed Roller Central Feeding System

The dispatching and feeding time of the high-speed roller automatic feeder is through dispatching the position of the migratory disc connected with the punch. A simple way is to stop the punch at the angle of the demand feeding, and then to dispatch the screw on the scale ring of the migratory disc to form a straight line with the pull rod. As for the scale ring, it is still facing downward or upward, and look at the punch machine. It depends on the type of fully automatic feeder. Assuming that the time of fully automatic feeder is exactly the opposite when the scale ring is down, it is only necessary to turn the scale ring upward.


Central Feeding System

3. NC NC Fully Automatic Feeding Machine Feeding Time Scheduling

The feeding time of NC NC fully automatic feeder is scheduled by connecting the feeding signal line with the punch cam. The cam components are divided into mechanical and electronic ones. Assuming the mechanical type, it is necessary to turn over the signal box of the cam group and find the cam connected with the feeding signal line of NC fully automatic feeder. Then the cam angle is scheduled to meet the feeding demand. Intermediate adjustment to the signal on the line, assuming that the electronic cam needs to input the punch angle of the desired feeding time in the punch's man-machine interface. Another is that the traditional punch has no cam group signal. When NC fully automatic feeding machine is equipped, a set of two cams will be installed on the brake shaft of the punch. One is the feeding signal cam, the other is the relaxing signal cam, and the other is the two micro-switch. This type of scheduling feeding time requires the cam to find the feeding signal. Then loosen the screw that fixes the two cams, and adjust the feeding cam to the required feeding time. Note: Relax the cam angle carefully and don't change it.


Recently Viewed: