天富娱乐登录测试

about us
current position: HOME >> News >> Industry News

How to Deal with the Noise Problem of Automatic Feeding System

2019-02-26
Times

Noise will occur in any mechanical equipment during operation, and automatic feeding system is no exception. For operators, long-term operation in noisy environment is indeed a headache, especially in summer, the whole person will feel more irritable. It has been impossible to silence the automatic feeding system. It is still necessary to reduce the impact of noise. Here is a question about how to deal with the noise of the automatic feeding system, which is answered by the technicians of Zhangjiagang Reijie Machinery.


Automatic feeding system


Understand the characteristics of automatic feeding system for polishing power. In the production process of polishing machine, the oscillation of the machine's dynamic elasticity and the collision of objects occurs, which is called the production oscillation. The number of oscillations per unit time is called oscillation frequency in Hz. The displacement change of oscillator in unit time is called velocity and unit M/S. The key to the polishing machine operation is to remove the damage layer which occurs during polishing, and to get the maximum polishing rate. The finest material is used before and after polishing to make the polishing damage layer shallow, but the polishing speed is low.


First, three-phase power supply is connected. Three-phase power supply is the number of power circuits on the motherboard. At this moment, we should find professional electricians to repair it. We should not check it privately, and there is a risk of electric shock.


2. Without polishing machine for a period of time, there is a small amount of dust on the surface of the polishing machine. When the polishing machine is used again, the bearing rust causes the motor to not roll over and noise occurs. At this moment, the power supply should be blocked, the polishing disc should be rolled over by hand, and the power supply should be connected again. Assuming that the rolling is still not possible at this moment, the bearings need to be replaced.


3. Touch the motor by hand and feel tied up, which means that the motor is broken and should be replaced.


4. Assuming that the automatic feeding system announces greater dynamics than usual in the course of operation and that the polishing disc is quietly shaking, it may be that the bearing is broken and needs replacement.


Fifth, when the turntable is not working normally, noise will also occur, then the dial must be calibrated with a dial indicator.


Recently Viewed: